CNC Wire EDM cutting machine model DK7730

This looks like its never been used but still a Project and needs some work, Please read the full description for all information I have below.

This looks to be a CNC Wire EDM cutting machine DK7730, and it Looks like never used from new.

This is un-tested and not wired in or powered up, as I have no idea on how it works so is being sold as a project needing some work, however I am sure someone with basic knowledge will get this running in no time!.

This is being sold on behalf of someone else as part of a clearance.
I know very little about this machine other than what the pictures show and as described below, so can’t answer any questions about it and it is being sold as seen.

I believe Its a model DK7730, looks like it can do very precise CNC wire erosion cutting.
It looks to be a multi axis CNC EDM wire cutting machine, as it looks like the top wire feed platen has a two stage motor control which I assume enables the wire to tilt for tapered type cuts and angled cuts.
Whilst the main table looks like it has X and Y control, as there is an X8 control box with inputs and outputs and a runs on mach 3.

This is a new machine that has been unused but this is being sold as Project machine due to it’s current state.
The story I have been told is that the deceased owner bought this as a brand new machine and has never used it, the main controller which is the tall cabinet in the middle got damaged in transit from the supplier, so he got the small T9 cabinet and he was in the process of retro fitting it when his health deteriorated.

Inside the back of T9 cabinet, I found some cables with connectors that plug into the main wire erosion machine. All as shown in the pictures.
To me, this all looks new and unused; it literally has never been wired in.
The T9 box looks to have a hand-held controller hard wired in.

So It is being sold as seen as a project for someone to sort out, but the main machine is in great un-used condition which can be seen in the photos and if you know what your doing I am sure that it could have a mach 3 cnc control or a centroid acorn control or similar retro fitted to get it working in no time.

Collection by buyer only and cash on collection.
It is located in a workshop with a concrete drive access, and is on a buyer collection basis only.

!! This can only be viewed and collected on Fridays TBC !!

——-

This is part of a workshop clearance and is located in Woking , UK

We are open to offers based on current market value.
Please make your best offer of what it is worth to you.
Silly offers will not be replied to.